Search found 5 matches

by jmp
Jun 10 2021 5:25am
Forum: EBike Non-hub Motor Drives
Topic: New "TSDZ2 Torque Sensor Central Motor"
Replies: 8748
Views: 959665

Re: New "TSDZ2 Torque Sensor Central Motor"

... You may find the proper wire from the 6 wire cable going to the display, but you need to solder that and a ground wire to a connector or directly to the brake sensor. Indeed your help is really precious, Thanks a lot to both of you ! It helps me to find my mistakes and to make huge progress... ...
by jmp
Jun 08 2021 11:05am
Forum: EBike Non-hub Motor Drives
Topic: New "TSDZ2 Torque Sensor Central Motor"
Replies: 8748
Views: 959665

Re: New "TSDZ2 Torque Sensor Central Motor"

.... The brakesensor is normally an open connection and when pull the brake the input wil shorted to GND. Only way to check is if the motor rotates or not. If the connection is swapped the motor will not run. Thanks again for your answer. I will do a few tests. But if anyone has the wiring descript...
by jmp
Jun 08 2021 6:55am
Forum: EBike Non-hub Motor Drives
Topic: New "TSDZ2 Torque Sensor Central Motor"
Replies: 8748
Views: 959665

Re: New "TSDZ2 Torque Sensor Central Motor"

I have tried to understand what you want, but for what I see is that you want to use a throttle cable for a brake cable. Imho with the 2pin connection, gnd in that case is missing. Throttle is +5V and throttle input and the brake is a gnd and brake input. I haven't experience with these connections...
by jmp
Jun 07 2021 2:41am
Forum: Motor Technology
Topic: Tsdz2 firmware open source adapted to vlcd5, vlcd6 and xh18
Replies: 1652
Views: 193635

Re: Tsdz2 firmware open source adapted to vlcd5, vlcd6 and xh18

Hello to all of you and congratulations for this excellent job with this OSF firmware ! I am new in this forum so, maybe, I don't post at the right place, I apologize for that if it is the case. I have a 8 PIN TSDZ2 controller, (throttle and ebrake functions) an XH18 Display, and I tried to install ...