I am a newbie to ebikes and just acquired the following setup from Grin.
9C 2706
35A controller, 36V.
It is a steel fork; the bike is a KHS Flite 220 (road bike/commuter bike).
Step 1: (No Torque Arm, but with torque washer)
The wheel refuses to stay on my dropouts; even at 20% throttle I experienced spin-outs (without a torque arm). I did have a V2 torque arm from Grin; but the motor's thread was too coarse and the torque arm would not slide over.
The attached image is the drop outs after a couple of spin outs. The side which had beat up the fork more was the one where the motor wire comes out.
Step 2: (with Torque Arm).
This is where I am looking for advice.
What is the best long term solution? Dr Bass? can I weld it on to my fork.
Any suggestions for welders in the Burnaby area. Anyone from BCIT?
Anybody have a couple of Dr Bass' arms I can buy for front forks?
I do have torque arms from Grin; would they cut it?
I will be hauling back and forth from work everyday to Burnaby mountain and
need something that lends me confidence to replace my car.
PS: Can I continue to use this fork?
Regards
9C 2706
35A controller, 36V.
It is a steel fork; the bike is a KHS Flite 220 (road bike/commuter bike).
Step 1: (No Torque Arm, but with torque washer)
The wheel refuses to stay on my dropouts; even at 20% throttle I experienced spin-outs (without a torque arm). I did have a V2 torque arm from Grin; but the motor's thread was too coarse and the torque arm would not slide over.
The attached image is the drop outs after a couple of spin outs. The side which had beat up the fork more was the one where the motor wire comes out.
Step 2: (with Torque Arm).
This is where I am looking for advice.
What is the best long term solution? Dr Bass? can I weld it on to my fork.
Any suggestions for welders in the Burnaby area. Anyone from BCIT?
Anybody have a couple of Dr Bass' arms I can buy for front forks?
I do have torque arms from Grin; would they cut it?
I will be hauling back and forth from work everyday to Burnaby mountain and
need something that lends me confidence to replace my car.
PS: Can I continue to use this fork?
Regards