Help in San Francisco (cycle A + castle creation)

jucasan

10 mW
Joined
Mar 2, 2015
Messages
25
Anybody here from SF who knows how to connect cycle analyst and a phoenix edge hv 80? It's working but have some issues and can't figure out what is going on.

If someone can help me would be great.

Thanks
 
I have a CA version 3.0, a Grin thumb throttle, Astro Flight 3205 and a Phoenix edge hv 80.

This is the setting in the CA

Throttle Input Settings
Input Throttle Mode Pass-thru
Zero Throttle Threshold 1V
Full Throttle Threshold 4V
Fault Throttle Threshold 4.35V
Throttle Auto Cruise off
Cruise Hold Range .15V

Throttle Output Setting
Output Mode RC pulse
Max Throttle Output 3.65V
Min Throttle Output 1V
Ramp Down Rate 4V/sec
Ramp Up Rate 2v/sec
PAS Ramp Up Rate 1V/sec
Fast Ramp Up Rate 4V/sec
Fast Ramp Threshold 3:00 AM

When plugged in I have in the controller a yellow light and a red blinking one. When I start to squeeze the throttle the motor works and the red LED in the controller stops blinking. But when the throttle reaches half way the red LED start blinking again and if I go full throttle the motor stops.

I appreciate any help with this project. I'm really frustrated. I thought it was plug and play sort of thing but is more difficult than I expect it.

Thanks
 
Back
Top