Help, new controller, motor not stopping

Talk about anything and everything here within reason.
Post Reply
Charmz
1 µW
1 µW
Posts: 2
Joined: Jan 11, 2018 8:46 am

Help, new controller, motor not stopping

Post by Charmz » Jan 11, 2018 8:56 am

Hi everyone, need some help here if you can. I just bought a new controller and connected all wires as instructed. when i turn on scooter, motor keeps turning, brakes do nothing, throttle does nothing, 3-speed does nothing. On first connection with system, wheel was turning in reverse, but i switched the blue and green hall sensor wires to make it move in forward but in both cases from time bike is switched on it just keeps spinning. Help

User avatar
fechter
100 GW
100 GW
Posts: 11962
Joined: Dec 31, 2006 3:23 pm
Location: California Bay Area, USA

Re: Help, new controller, motor not stopping

Post by fechter » Jan 11, 2018 10:42 am

There must be some throttle input. Try disconnecting the throttle. If still runs, make sure you really have the right wires going to the throttle. It's suspicious the brake input doesn't stop it though. If disconnecting everything except the motor doesn't stop it, then the controller must be bad. If disconnecting the throttle stops it, then you might have a bad throttle, which is not uncommon.
"One test is worth a thousand opinions"

Voltron
100 kW
100 kW
Posts: 1320
Joined: May 02, 2013 4:53 pm
Location: Santa Barbara CA

Re: Help, new controller, motor not stopping

Post by Voltron » Jan 11, 2018 12:53 pm

If you for sure have your brake disconnects hooked up, and the brake isn't making the motor cut out, then that is probably a serious controller problem.

Charmz
1 µW
1 µW
Posts: 2
Joined: Jan 11, 2018 8:46 am

Re: Help, new controller, motor not stopping

Post by Charmz » Jan 11, 2018 2:36 pm

thanks for diagnosis, i figured that much but needed an unbiased second opinion.

User avatar
amberwolf
100 GW
100 GW
Posts: 24197
Joined: Aug 17, 2009 6:43 am
Location: Phoenix, AZ, USA, Earth, Sol, Local Bubble, Orion Arm, Milky Way, Local Group
Contact:

Re: Help, new controller, motor not stopping

Post by amberwolf » Jan 12, 2018 1:14 am

If the ground wire on the throttle is not connected, many controllers will run the motor, even if the throttle is "off", because it sees a voltage on the throttle input that isn't "really" there.


Also if it has a "learn" function, sometimes if that is left connected the motor will just keep running.

Post Reply