Replacing a mosfet

JamieWlcox

10 mW
Joined
Mar 5, 2018
Messages
24
When replacing a bad or blown mosfet and doing an upgraded to irf4110 mosfet is it required to replace all 15 or can they be replaced as needed
 
You need to closely match the mosfets.
Something called "miller plateau matching"

https://endless-sphere.com/forums/viewtopic.php?f=3&t=85710&p=1253926&hilit=blown+mosfet+replace#p1253926
Even if you find and replace the blown MOSFET there may be other components that were fried as well. For most people it is more practical to replace the controller.
 
If replacing like-for-like I don't think you need to match the FETs. It's no doubt good practice but I doubt this is done at the factory when the controller was originally made.
 
Back
Top