how to program a sevcon gen4

General Discussion about large electric scooters and motorcycles and other things with no pedals.
jenwu
1 µW
1 µW
Posts: 4
Joined: Dec 04, 2017 6:27 am

Re: how to program a sevcon gen4

Post by jenwu » Dec 05, 2017 11:47 am

Hi,
I'm doing torque control on a BLDC motor. I have some problems with getting the torque over 10 Nm. It seems like I can't get more than 50A, actual AC current (Iq,) even though I set the max amps to 100A. And the max torque is 100Nm. I'm using a battery bank, 84V, that should be able to drain a lot more. Is there some setting in DVT that I've missed to change?
Thanks!

bernext
10 µW
10 µW
Posts: 6
Joined: Apr 19, 2018 5:23 pm
Location: Mexico City

Re: how to program a sevcon gen4

Post by bernext » Apr 24, 2018 4:29 pm

frodus wrote:
Dec 08, 2015 4:11 pm
updating the thread, since people can't figure it out after things moved on the Heinzmann site

Go here:
http://www.heinzmann.com/en/download-el ... s-software
Then navigate the tree to "Motor Controllers", then "Software" then "Sevcon Software" and click on "Sevcon Install".

You will need to login with
Username : software
Password : perm-motor2010
Hi Frodus,

Is there any chance you might have an updated username and password for the heinzmann site? Those ones posted in 2015 are no longer valid.

Regards.

Post Reply