Magura 5K twistgrip throtthle and Kelly Kls 200

Joined
Jun 21, 2018
Messages
12
Hi,
i bought the mighty magura throttle, but can't get it to work smooth.
My controller don't start if i activate the 0-5 k mode when i set it to 3 in the tps square. When its set to 1 or 2 = 1-5v , 1-4v the motor starts, but very hard. Its not very smooth like i wouldhave it to be, how can i get it to work right. Thanks :) :wink:
 
The Magura is a terribly overrated and underperforming throttle, best to get a Domino.
 
I now soldered a 10 k poti i took from a subwoofer modul that should move to the recycling station between the plus wire but now i got the axle bent because the motor stops abrupt if i close and open up the throttle a little... does anybody now which setting in have to change, i had free today and tried the half day to get things right :?
 
Did you put the resistors in place properly? Im not sure if you need to do this with the kelly controllers but you had to to make them work with lyen/infineon clone controllers. This old vid of mine shows how to do it.
[youtube]dFnpV34gKtA[/youtube]

If you do this you may be able to leave the kelly settings alone as they are stock
 
Back
Top