Hi All,
I have the above controller connected to a ME1115 motor which uses a SinCos sensor on my motorcycle.
I can get the drive to do angle identification & have set the correct values for amplitude & zero crossing.
The motor runs when the rear wheel is off the round but under any kind of load it trips on Hall Error.
Anyone had similar experiences?
I have the above controller connected to a ME1115 motor which uses a SinCos sensor on my motorcycle.
I can get the drive to do angle identification & have set the correct values for amplitude & zero crossing.
The motor runs when the rear wheel is off the round but under any kind of load it trips on Hall Error.
Anyone had similar experiences?