Page 1 of 1

BMS balance wires with 10K resistors and solder blob...what is this?

Posted: Jun 08 2019 7:24am
by newb123
During a Li-on pack disassembly I found that the balance wires to the cells had shrink tube covering solder blobs then a thin wire from that to a 10K resistor (see pic) Just wondering what the 10K is for; I can understand the thin wire and solder blob might be a fuse of sorts, but why the 10K?

perhaps some kind of current sensing for the BMS?
IMG_8836.JPG
IMG_8836.JPG (66.91 KiB) Viewed 260 times