ethicHacker
1 µW
- Joined
- Jun 21, 2021
- Messages
- 3
I'm working on a lightweight BMS for drone batteries (https://rotoye.com/batmon-v5-board-information/). A skateboard enthusiast mentioned that it may be interesting for the DIY skateboard and e-bike makers. The stock BMS does not have FETs to disable and enable charge/discharge.
Happy to discuss if this is interesting for any of you makers.
Specs:
Happy to discuss if this is interesting for any of you makers.
Specs:
- Monitor Lithium battery packs(3S-12S) and performs cell-balancing
- Install in a matter of minutes with the optional install kit (coming soon. Email us for questions)
- Connects to JST XHP female balance leads of battery pack
- Optional OLED Display: Show battery related information for easy reading.
- Communication Protocol:
- SMBUS: I2C based 2-wire protocol supported in firmware. Communicates to PX4, Ardupilot, ROS, Arduino, etc
- CAN-FD: 2-wire high speed CANBUS interface
- Continuous Current supported: 120A
- Power and data connector: Prolanv
- Supported wire gauge of battery power leads : 12AWG – 8AWG.
- External Thermistor