No frills, lightweight Battery management system(BMS)?

I'm working on a lightweight BMS for drone batteries (https://rotoye.com/batmon-v5-board-information/). A skateboard enthusiast mentioned that it may be interesting for the DIY skateboard and e-bike makers. The stock BMS does not have FETs to disable and enable charge/discharge.

Happy to discuss if this is interesting for any of you makers.



Specs:

• Monitor Lithium battery packs(3S-12S) and performs cell-balancing
• Install in a matter of minutes with the optional install kit (coming soon. Email us for questions)
• Connects to JST XHP female balance leads of battery pack
• Optional OLED Display: Show battery related information for easy reading.
• Communication Protocol:
  • SMBUS: I2C based 2-wire protocol supported in firmware. Communicates to PX4, Ardupilot, ROS, Arduino, etc
  • CAN-FD: 2-wire high speed CANBUS interface
• Continuous Current supported: 120A
• Power and data connector: Prolanv
• Supported wire gauge of battery power leads : 12AWG – 8AWG.
• External Thermistor