dogman dan
1 PW
My first thread on how to paralell some lipo used a method allowing a temporary connection. It used less connectors than making paralell adaptors, but still uses a lot of andersons.
Here is another way, more permanent, but still using the crimp sleeves. Here you see the black wire done, and the crimp sleeves found in a hardware store electrical section. Basicly you stuff all three wires into the sleeve, and crimp, then fold the crimp over by crimping agian 90 degrees from the first crimp
For the balance wires, I run the pack with em disconnected, and use something like this, when I do want to balance them. You buy two of the jst connectors, and cut in half, then connect in a y, to make a paralell charging adapter.
Another pic, while doing the red side.
You can take the left over 4mm connector, and make an anderson adapter if you want to connect with andersons, or just use the 4mm connectors.
Here is another way, more permanent, but still using the crimp sleeves. Here you see the black wire done, and the crimp sleeves found in a hardware store electrical section. Basicly you stuff all three wires into the sleeve, and crimp, then fold the crimp over by crimping agian 90 degrees from the first crimp
For the balance wires, I run the pack with em disconnected, and use something like this, when I do want to balance them. You buy two of the jst connectors, and cut in half, then connect in a y, to make a paralell charging adapter.
Another pic, while doing the red side.
You can take the left over 4mm connector, and make an anderson adapter if you want to connect with andersons, or just use the 4mm connectors.