maarkmohamed
100 W
- Joined
- Jan 10, 2019
- Messages
- 114
Hello guys, I was suggested to come over here from another forum I was told you guys would be about to help me figure out my problem. I am currently in the process of building a complete electric dirt bike and I'm just about to start with the battery portion. However the problem I've been thinking about is, I'm looking to make a total of 35-45kw of power and I'm most likely going to be drawing from the battery around 500+ amps. Now my battery configuration is going to be something like a 28s 11p setup. Now when the battery is all done and I need to connect the positive and negative lead from the battery, how do I do this in a way which will allow me to safely draw 500-600 amps? Now obviously I'm going to have to go with some very thick gauge wire and you wouldn't be soldering something like that. And so I'm most likely going to have to use bus bars connecting the whole thing. And from the bus bar in going to connect the positive and negative leads. But how thick of a bus bar do I need, and how exactly should this be done? Hope my question is clear.
Thank you in advance for your help.
Thank you in advance for your help.