Any help would be appreciated,,, new ebike conversion. I bought the kit from china. rear hub 48V 500W with disc brakes.
I could use some input from a knowledgeable source
I have everything wired up. Very good charge on my battery. Power going to throttle light "indicator lights", brakes contacts are closed and in the ready position... ( I also disconnected them to rule them out), PAS on the pedal and a mere 2mm from the magnets... all connections are triple checked. I turn on the battery... as I mentioned the lights light up on the handlebar... but i get no power to the wheel as I twist the throttle. I unplug the motor connection and put a voltmeter on the controller motor output, and the volts stay at a steady 4.5V when I twist the throttle.
Any suggestions?
I could use some input from a knowledgeable source
I have everything wired up. Very good charge on my battery. Power going to throttle light "indicator lights", brakes contacts are closed and in the ready position... ( I also disconnected them to rule them out), PAS on the pedal and a mere 2mm from the magnets... all connections are triple checked. I turn on the battery... as I mentioned the lights light up on the handlebar... but i get no power to the wheel as I twist the throttle. I unplug the motor connection and put a voltmeter on the controller motor output, and the volts stay at a steady 4.5V when I twist the throttle.
Any suggestions?