self learning wire

seanau

10 µW
Joined
Jul 28, 2019
Messages
6
Hello again,

I am trying to research about how this process works.

I connected the white self-learning wire, and the wheel spins forward, so i then disconnect the self learning wire as what it says. Then i attempt to use the throttle and nothing happens. I turn it off and back on and it throttles for 2 seconds and stops.

Thanks
 
That's not normal, but I have no idea why. Once you beep the throttle with the self learn wire connected and the wheel goes forward, it should set itself and run fine. If it was something else, like your motor wire plugs are loose, it should not have run with the learn wire connected. But, since its always something like that, check that again anyway and try it again.

Thinking again, check your throttle plug and wires.

I have gotten a brand new controller that is junk a few times, so maybe that is the deal here. Get the vendor to send you another.
 
Back
Top