Suzhou KT-LCD1 Cruise Control.

Get all your technical information about electric bikes here.
Post Reply
kizzer   1 µW

1 µW
Posts: 3
Joined: Aug 03 2019 12:26pm

Suzhou KT-LCD1 Cruise Control.

Post by kizzer » Aug 03 2019 12:36pm

Hi Guys

I have been unable to enable the Cruise Control function with my controller.

I have been following the instructions I have found online which said:
After finishing P parameter settings, the P5 parameter stops flashing. Within 1 minute after stopping flashing, hold “up” and “down” for about 2 seconds to enter the C parameter setting environment.
On my controller the P5 parameter flashes for about 1 minute and then instantaneously goes back to the start screen. If I press the Up and Down buttons together it goes to the P parameter settings again.

Is this the way it should be? Am I just not getting my timing right?

Thanks for any help you can give.

Kieran

docw009   100 kW

100 kW
Posts: 1112
Joined: Aug 02 2015 7:43am
Location: Chicago area suburbs.

Re: Suzhou KT-LCD1 Cruise Control.

Post by docw009 » Aug 04 2019 2:09am

Are you sure you meant LCD1? My LCD1 controller only has P1-P5. You can buy a LCD3 or a higher lever controller that has the additional C parameters.

LCD1 has the buttons in the same case.
P1150355.jpg
P1150355.jpg (80.76 KiB) Viewed 114 times
LCD3 has the buttons in a separate unit.
P1650331.jpg
P1650331.jpg (160.09 KiB) Viewed 114 times

kizzer   1 µW

1 µW
Posts: 3
Joined: Aug 03 2019 12:26pm

Re: Suzhou KT-LCD1 Cruise Control.

Post by kizzer » Aug 04 2019 2:30am

Yes it's the all in one controller LCD1.

So the 'C' parameters can't be accessed on the LCD1? The manual says it has cruise control, but without the ability to change the C7 value it's unusable.

kizzer   1 µW

1 µW
Posts: 3
Joined: Aug 03 2019 12:26pm

Re: Suzhou KT-LCD1 Cruise Control.

Post by kizzer » Aug 04 2019 5:13am

Here's the section from the advanced manual that shows it.

Image

When I try to do this, it tries to put the bike in walk mode.

docw009   100 kW

100 kW
Posts: 1112
Joined: Aug 02 2015 7:43am
Location: Chicago area suburbs.

Re: Suzhou KT-LCD1 Cruise Control.

Post by docw009 » Aug 04 2019 11:04am

Many KT controllers have a connectors that can be jumpered to enable cruise control.
cruise.jpg
cruise.jpg (36.38 KiB) Viewed 98 times

Post Reply