LewTwo
1 MW
I am trying to locate an intermittent fault in my Golden Motor V4 front hub motor system. It acts like a loose wire ... start fine, goes a few feet and cuts out ... rinse, wash and repeat. So I found a lose wire in the BAC-601 display and decided to re-terminate the cables. I am posting my documentation here for posterity in case someone else may find the information useful.
Now for a bit of Trivia:
I closely examined the PCB to see if there were any obvious faults (i.e blown resistor, capacitor, etc.). I discovered what I think is a most unusual feature.
I do not believe that 'extra' capacitor was part of the original design.
Now for a bit of Trivia:
I closely examined the PCB to see if there were any obvious faults (i.e blown resistor, capacitor, etc.). I discovered what I think is a most unusual feature.
I do not believe that 'extra' capacitor was part of the original design.