WXBULL controller wiring help***

akookie

1 µW
Joined
Feb 10, 2015
Messages
1
Location
GC , Australia
Hey I was wondering if anyone could help me. I've got a WXbull 2000w controller and the voltage says 48/ 60v /64 / 72v / 84v . Now is that controller ready to run 84volts.. or do I have to solder something on the PCB board. Because there is a spot on the board that has 60v / 64v / 72v / 80v. Can anyone help me.. I only noticed the numbers written on the pcb board as I was soldering up the shunt..

Cheers
 

Attachments

  • 162395799485671743654729181259.jpg
    162395799485671743654729181259.jpg
    278.3 KB · Views: 396
  • 16239580341375378861014061563018.jpg
    16239580341375378861014061563018.jpg
    245 KB · Views: 397
  • 16239580577185787238006304438717.jpg
    16239580577185787238006304438717.jpg
    269.4 KB · Views: 396
That is for low voltage cutoff and such. Install jumper connecting your size battery.If you dont put a solder slug across it should act as if it is run by 48v. I have a 3kw controller by wx bull that has the same thing but it's common for most cheap Chinese controllers.
 
Back
Top