CA V3 CA-DPS TO CA-DP MOD

Get all your technical information about electric bikes here.
Post Reply
User avatar
Emoto   10 kW

10 kW
Posts: 529
Joined: Jun 13 2011 9:31am
Location: Australia

CA V3 CA-DPS TO CA-DP MOD

Post by Emoto » Dec 20 2013 8:35am

Hi
Im in need for some tech on modding the v3 to getting speed data from the controller halls.
I know i have to replace the white wire on the sp pad thats used for the wheel magnet , for the yellow unterminated from the 6 conductor CA-DP harness.
Thing is im not sure on the black wire going to board [ black boxed in pic ] ?? i know its the ground from the wheel speed sensor but is it common ect .....
Attachments
SAM_0651.JPG

User avatar
teklektik   10 GW

10 GW
Posts: 4020
Joined: Mar 26 2011 1:15pm
Location: CT, USA

Re: CA V3 CA-DPS TO CA-DP MOD

Post by teklektik » Dec 20 2013 3:57pm

Nope - it's just specific to the wheel sensor.
  • unsolder both black and white wheel sensor wires
  • Attach yellow CA-DP wire to Sp pad.
  • Set new pole count.
Done! :D
Visit Grin Technologies at www.ebikes.ca
Build Thread: 2WD Yuba Mundo V4

User avatar
Emoto   10 kW

10 kW
Posts: 529
Joined: Jun 13 2011 9:31am
Location: Australia

Re: CA V3 CA-DPS TO CA-DP MOD

Post by Emoto » Dec 21 2013 9:51am

Awesome All done, DPS is now a DP.
Thanks for the tec tekektic :D

botz244   10 W

10 W
Posts: 89
Joined: Oct 06 2011 2:13am

Re: CA V3 CA-DPS TO CA-DP MOD

Post by botz244 » Dec 26 2013 8:41am

does this go for the CA v2.3 also
untill i can get my v3 going agian

User avatar
teklektik   10 GW

10 GW
Posts: 4020
Joined: Mar 26 2011 1:15pm
Location: CT, USA

Re: CA V3 CA-DPS TO CA-DP MOD

Post by teklektik » Dec 26 2013 9:06am

Yep. Same mod will work there as well.
(Page 22 of CA 2.3 User Manual briefly describes possible sources of signal for Sp pad on circuit board.)
Visit Grin Technologies at www.ebikes.ca
Build Thread: 2WD Yuba Mundo V4

botz244   10 W

10 W
Posts: 89
Joined: Oct 06 2011 2:13am

Re: CA V3 CA-DPS TO CA-DP MOD

Post by botz244 » Dec 26 2013 3:07pm

Yep got it done thanks

Post Reply