...and.. recommended software..teklektik wrote:
- Controller must be powered off via 'ignition' wire or disconnected from the bike battery if 'ignition' wire is jumpered to controller Vbatt+ wire.
- Do not use extender cable (either USB or Audio TRS).
- Try a different USB port that can supply sufficient power (needs to run the controller processor and flash the memory). It may help to disconnect other accessories that draw 5V power from the controller (throttle, PAS sensor, 3-pos switch) to minimize USB power requirements.
- Press and hold the cable 'FlashMe!' button after you click transmit.
MXUS 3000 Hub Motor
Detailed here: XPD: open-source keywin e-bike lab replacement -and- Programming the infineonzombiess wrote:You can use xpd. .arkmundi wrote: Which means the capability to do that. I was surprised that Cellman provided NO information or software or anything other than the USB cable on the controller. So now I'm left with the good members of the ES forum to enter the information vacuum. Reference to good threads, reads on the how-tos would be most appreciated.
..and much more here at zapparello's wiki: https://code.google.com/p/xpd-ebike/wiki/Entry
Am in luck, since I run with Ubuntu...
.. yielding a clean, painless and working install.zapparello wrote:If you're using the Ubuntu/Debian or Fedora Linux distributions, just download the respective binary package (.deb or .rpm respectively) from the subdirectory with latest version number and install it.