jatgm1
10 W
to get right to the point, i have a 1000w 48v cheap hub motor kit with a battery from "sunthing28" (i belive the battery is fine) and recently have run into a problem. i am riding my bike, just like everyday, and while i am riding the motor simply stops propelling me forward. the lights that indicate the battery life, located on the throttle, are still lit. then it starts propelling me forward again. it has been getting progressively worse. i have made sure all the connections i made, (wireing the battery to the motor controller, the plugs to the wires) are properly connected. the plug from the motor controller to the throttle is a plug, and is plugged in. the three colored wires going from the motor controller to the motor are enclosed in a small yellow plastic box thing which i have not yet checked (that is my next task which i will do in a few minutes) the other connector going from the motor controller to the motor was plugged in, however after i had the problem i thought maybe that was what was causing it so i shut the bike off, unplugged said white connector, and turned it on, for the problem to persist. i tried unplugging the plugs that went to the throttle, thinking maybe it thought i was hitting the brakes. after turning it off, unplugging the brake wires, and turning it back on, the problem persisted. does anyone have any suggestions? comments or concerns? i would greatly appreciate them. how would i find out what is wrong and fix it? p.s. i have a cheap voltimeter at my disposal. i think it may be broken though. i know the battery is dead, other than that, no idea.