Voltron
1 MW
I have a couple of matched low power controllers sitting around, so going to try the paralleling thing on them for the experience, and could use some tips before letting the smoke out. So I have the phase wires are Y-ed out to go to both, and on the Halls, the three signal wires are Y-ed, with the red and black coming off of one controller. So the big question is does the black/red not get wired into the other controller at all, or does the black get hooked up too? In other words, does the second controller just need the signal input from the Halls? And will it basically be the same for the throttle wires?
Thx ahead of time...
Thx ahead of time...