i had this controller for a bit over a year now, was running it sensored with my old dd hub, till it went bonkers outta nowhere (axle began to strip from overtightening/ craptastic material) so ordered a cheapish halless controller to use with another motor i got. So figured why not toy around with this and see if its possible to convert this to halless some how. i popped it open and noticed there's quite a few bare labeled pins and after some digging i have been given hope that the 6/12 pin thaTS label on the pcb have something to do with it not sure if the mcu gives the final say to running halless but surely that pin does something. any one with this controller?