Sabvoton SVMC settings for 80 amps max..

Hello people, im reaching 70 kph with 3000 Watts on a 72V Battery that can output 80 amps max... (20s8p, lg Mg1) the acceleration with 26 x 3 T QS205 V2 is a bit weak.
Will enabling boost on sabvoton help me to minimize the issue ? also is there a setting on throttle voltage which can minimize the lag ? i have putted the reaction time on 10ms.. but perhaps i need to increase the throttle voltage ? but how much ?

Thanks in advance..

Hi,

Tell me a bit more about your setup.
Do you have the temp sensor working?
Have you set up the 3 position switch on the CA V3?
Which SVMC model do you have?
Is the throttle wired through the CA V3?
If so have you set the up and down throttle rate on the CA V3?

Let me know as I have 3 SVMC72150 and 1 SVMC72200 controllers connected to CA's and various motors including QS 205

Jonno

Is the controller version SVMC 72xxx (M) may cause poor acceleration than normal SVMC without (M) ?

3t in 26 wheel is generally bad setup, especially for acceleration.
May be you have a chance to lace it in smaller wheel?

Also those mj1 will sag like crazy under max amps..