Hello all fellow ebikers!
I have finally decided to order a better frame for my ebike and and i am going to use my old setup which consists of following parts:
Hallomotor 1500w hub motor ferrofluided.
12 FET IRFB4110 Infineon controller.
75v Diy Battery.
I am currently pulling maximum of 3500 watts (Gets me going 70 km/h ) and controller only gets mildly warm because it gets proper ventilation. I was planning to put controller inside the Electric Enduro frame because i love the clean look of it. Will my controller overheat?
Waiting for your answers!
I have finally decided to order a better frame for my ebike and and i am going to use my old setup which consists of following parts:
Hallomotor 1500w hub motor ferrofluided.
12 FET IRFB4110 Infineon controller.
75v Diy Battery.
I am currently pulling maximum of 3500 watts (Gets me going 70 km/h ) and controller only gets mildly warm because it gets proper ventilation. I was planning to put controller inside the Electric Enduro frame because i love the clean look of it. Will my controller overheat?
Waiting for your answers!