IanM
100 W
I ordered some motors and other stuff from BMS Battery including a q100h rear hub motor and I discovered a problem with the q100h axle. The problem is with the axle flats not being aligned so that when one side is in the frame dropout the other side is about 45 degrees out and will not fit at all. I have sent a lot of emails to them to try and get the problem resolved but so far they are being less than helpful, it seems like they don't believe what I have shown them with photos and explaining. So my question is, can I fix this myself? If the axle is two pieces and not one solid piece then maybe it's an easy fix. If the axle is one solid piece then it's probably not I presume. Any advice would be appreciated.