when I've wired everything up,ive noticed the throttle wiring from the throttle end only has 3pins.
& the throttle connection on the controller end has 4pins, I know the fourth pin is for led throttles, which I'm not using.
The three pins go as this:
The red throttle wire is the 5V+ wire. Connect that to the 5V+ throttle wire from your controller.
The Black wire is the 5V- wire. Connect that to the 5V- throttle wire from your controller.
The white wire is the return wire that gives your controller the reference voltage which tells your controller how fast you want to go. Connect that to the return voltage wire on your controller.
Edit: Usually the three throttle wires have one connector from the controller. Look at the instructions to isolate the proper connector.
On the return voltage: 0 volts means stop...5 volts means wide-open-throttle. Your actual voltage might be a bit different like .8v at full stop and 4.8v at WOT.
From what you are describing, it sounds like you might not have it wired just right. The colors don't seem right.
is it safe for me to try twisting throttle .....
Lets make sure it is wired right before twisting the throttle
Also, the picture can't be that big. 640x480 is the size to use. Go to the bottom of the ES page. Hit attachments, add files and upload your 640x480 jpg.
Favorite Quote: "This is L.A., sugar. There is no 'over the top." --- Chris Erskine
Current build: Liahona w/ cheap front suspension and suspension seat post. Yescomusa 36v 800w generic front hub motor. 15ah Headway triangle mounted pack. Tronsung 30 amp,
Previous Build:1992 Trek Antelope 800 - Bone Crusher (no suspension) - Yescomusa 800 watt 36 volt front wheel kit. Don't do it! Get suspension!!!