luckyozone7
10 µW
Hello Forum, newby here so just learning how to use forum. I searched google and this forum and couldn't come up with anything that matched to what I have.
I pulled out an old 48v 1000w controller I bought back in 2010 from ebay ebike conversion kit and can not figure out the wiring. Does the following picture remind any older ebike builders what the connectors are for?
power 2pin molex red/black
Phase Yellow/Green/Blue
Hal 5pin molex red/black/yellow/green/blue
? 3pin molex red/green/black (i think this is throttle= red/black power green signal)
? 2pin molex blue/black
? 2x 3pin jst red/green/black (i think ebrake engine cutoff but there is 3 wires)
? 2pin jst red/black (i think on/off)
I had a thumb throttle with on/off and full/half/empty lights but I do not see another wire for voltage sense for the lights.
Take a look at the pics below and if you think you know please let me know, I want to mod it that way i will have a spare.
I pulled out an old 48v 1000w controller I bought back in 2010 from ebay ebike conversion kit and can not figure out the wiring. Does the following picture remind any older ebike builders what the connectors are for?
power 2pin molex red/black
Phase Yellow/Green/Blue
Hal 5pin molex red/black/yellow/green/blue
? 3pin molex red/green/black (i think this is throttle= red/black power green signal)
? 2pin molex blue/black
? 2x 3pin jst red/green/black (i think ebrake engine cutoff but there is 3 wires)
? 2pin jst red/black (i think on/off)
I had a thumb throttle with on/off and full/half/empty lights but I do not see another wire for voltage sense for the lights.
Take a look at the pics below and if you think you know please let me know, I want to mod it that way i will have a spare.