Hi!
I'm looking for ways to replace a MY1018E motor with a Denzel D4500 motor, but their shafts are not compatible.
I had difficulties finding a pre-made part just for this case, and I'm not sure if such even exists. Please, share how would you match the D4500 and the drive chain in the below image together.
I'm for the torque mainly, so solutions that would allow experimenting options between 7 and 11 tooth sprockets are preferable. OTOH, anything that works is better than nothing.
The chain is 8mm pitch.
The standard sprocket is 11T. Center hole is D-shaped and diameter possibly 8mm, can check if needed.
D4500 shaft diameter is 15mm, with a key groove. M5-threaded hole in the head.
MY1018E:
https://ibb.co/bSM50y
https://www.aliexpress.com/item/250...fbe-4ed6-9c04-9b407a5f07a9&priceBeautifyAB=0
Denzel D4500:
http://www.eastgem.net/d4500.html
Cheers!
I'm looking for ways to replace a MY1018E motor with a Denzel D4500 motor, but their shafts are not compatible.
I had difficulties finding a pre-made part just for this case, and I'm not sure if such even exists. Please, share how would you match the D4500 and the drive chain in the below image together.
I'm for the torque mainly, so solutions that would allow experimenting options between 7 and 11 tooth sprockets are preferable. OTOH, anything that works is better than nothing.
The chain is 8mm pitch.
The standard sprocket is 11T. Center hole is D-shaped and diameter possibly 8mm, can check if needed.
D4500 shaft diameter is 15mm, with a key groove. M5-threaded hole in the head.
MY1018E:
https://ibb.co/bSM50y
https://www.aliexpress.com/item/250...fbe-4ed6-9c04-9b407a5f07a9&priceBeautifyAB=0
Denzel D4500:
http://www.eastgem.net/d4500.html
Cheers!