dddddd said:Hi Yes you can Hook up 2 Motors.
I have a quick question Can you hook up 2 displays? And work? One for info Other had rfid Sensor to limit speed??? Please Inform me
dddddd said:... i have a sabvoton 72v 150a And the Wires Are so small i don't know if soldering will be possible I only want the speed limiting future.
And there is no shunt would a external Shunt work?
If you explain what is puzzling you I might be able to help, but you just need to wire up the parts exactly according to the picture - as they say, it's worth a thousand words...dddddd said:I can't Really Understand that Guide Mind helping me Step by step?
Yes.dddddd said:But will it still work if i solder as the guide says. Then i can connect it to CA3.1? and have all the features That it's capable?
yes!dddddd said:If I do as You Posted Will i Get all the Features Of the Cycle Analyst 3.1. I Manly want the Multiple Aux connections.?
That has nothing to do with the CA - it's merely representative of any typical ebike switch and fuse hookup and is an entirely different matter.dddddd said:This Part is confusing me. ...
What sort of Fuse and switch should i Attach Mind Linking me Fuse and Switch Please
No.dddddd said:Sorry. I Don't Know how to Make A thread. Just last Question So any type of fuse and A on/Off switch Would Work in This Section https://gyazo.com/1bf1cdb9049b45a55887f4ce16bb1b1f
Please see the CA3 [strike]Un[/strike]official Guide secton "Appendix D. Adding a CA-DP Connector to a Generic Controller".dddddd said:Hi. I have a sabvoton 72150 And i want All the Features of the cycle Analyst 3.1 But there is no 6pin to connect it to Cycle Analyst.
Can you Help me Please I'm Pretty Nooby Working with this stuff.
The shunt for which I posted the picture will handle 150A (see highlighting).dddddd said:Hi mate my Question is CAN the CA-SHUNT Work or dose it not Handle the current.
You are not answering my Question
dddddd said:My Controller is 72v 150a Motor 5000w 100ah. Battery 72v 29ah
dddddd's original questions were couched in terms of a single controller and motor with reference to a single motor/controller wiring diagram - I took this to be an off topic question about a CA with external shunt... The CA3 Guide which I referenced earlier mentions 2WD hookup in passing in section "4.2.1.6 Installation with Multiple Controllers (2WD)", but no wiring is detailed because the grounding and other issues were beyond the topic of the Guide.John in CR said:...that doesn't work if using 2 controllers (the topic of this thread), so a separate stand alone shunt is required through which the current of both controllers must flow for accurate measurement by the CA.