Hi, i've done around 100 miles so far on my q128c set up and its been flawless. Today however whilst fixing a puncture I knocked the connecters (don't ask) and a few of them bent slightly.
It still fits in the connector slots correctly and initially everything seemed alright.
However every so often it would just loose 100% of power and PAS / throttle would provide 0 watts of power. The display still worked and everything, but when pushing the throttle I would get a spinning icon where the temperature displays. I have seen this icon before but it was because the connectors weren't pushed in far enough.
However, turning the system on and off when cycling would allow the power to work as normal.
Any ideas on this / is it broken connectors?
It still fits in the connector slots correctly and initially everything seemed alright.
However every so often it would just loose 100% of power and PAS / throttle would provide 0 watts of power. The display still worked and everything, but when pushing the throttle I would get a spinning icon where the temperature displays. I have seen this icon before but it was because the connectors weren't pushed in far enough.
However, turning the system on and off when cycling would allow the power to work as normal.
Any ideas on this / is it broken connectors?