Hello, I am having issues installing a PAS sensor and hoping someone here can help me. I have updated my CA to V3.13 and am having problems installing a quadrature PAS sensor (12 poles) I bought from Grin tech. No matter what I do, the P arrow always follows the D arrow when pedalling forwards and not the other way around, and will not engage the motor. I have tried changing the Dir polarity and I have tried swapping and flipping the sensor and magnet ring itself but nothing will change it. Whether it is 5v=FWD or 5v=REV the arrows go in the same order, P following D. When I pedal forward the RPMs are going up, and it stays on 0 when pedalling backwards. When I pedal backwards the arrows go in the right order (D follows P) but still does not engage the motor. I've followed all the videos about it on youtube and read both the official and unofficial manuals but can't get it right.
Any advice is greatly appreciated I've spent so much time trying to figure it out I'm open to any ideas.
Thanks in advance!
Any advice is greatly appreciated I've spent so much time trying to figure it out I'm open to any ideas.
Thanks in advance!
