dilkes
100 W
Does anyone know the resistance is for the molded shunt that comes with the V2.3 Standalone? Mine seems to be acting up and I am trying to do some troubleshooting.
Many thanks.
Many thanks.
Cycle Analyst V2.3 Standalone Shunt Resistor
- Thread starter dilkes
- Start date
Killer-B
10 mW
The stand alone shunt resister from Grin is 1 OHM.
Regards
Killer-B
Regards
Killer-B
I thought (perhaps mistakenly) that the molded SA shunts were 1.0 milliohm?
http://www.ebikes.ca/shop/electric-bicycle-parts/ca-accessories/shunts/shunt-ca3.html
I couldn't find a reference in the 2.3 manual
https://www.ebikes.ca/documents/CycleAnalyst_V23Web.pdf
that actually said what it was, just that it came precalibrated to the included shunt, and that if setting a shunt resistance value, the best calibration is not to set it to the resistance, but to set it to show a correct reading based on a known-correct current reading.
http://www.ebikes.ca/shop/electric-bicycle-parts/ca-accessories/shunts/shunt-ca3.html
I couldn't find a reference in the 2.3 manual
https://www.ebikes.ca/documents/CycleAnalyst_V23Web.pdf
that actually said what it was, just that it came precalibrated to the included shunt, and that if setting a shunt resistance value, the best calibration is not to set it to the resistance, but to set it to show a correct reading based on a known-correct current reading.
