Please help.
A bike I recently finished for a friend, hit LVC whilst under full load... I'm suspecting by the BMS. At this point the Cycle Analyst also stopped functioning.
The Cycle Analyst stands alone, and uses a 3rd party shunt. For speed pickup I tapped a hall signal, and power is activated via the keyswitch - which also turns the controller on and off. (I have checked all wiring and continuity) The screen back-light appears, so it's getting power, but there is nothing on the screen.
Could the firmware of the CA been corrupted? or any other explanation or test to undertake??
thanks ES.
A bike I recently finished for a friend, hit LVC whilst under full load... I'm suspecting by the BMS. At this point the Cycle Analyst also stopped functioning.
The Cycle Analyst stands alone, and uses a 3rd party shunt. For speed pickup I tapped a hall signal, and power is activated via the keyswitch - which also turns the controller on and off. (I have checked all wiring and continuity) The screen back-light appears, so it's getting power, but there is nothing on the screen.
Could the firmware of the CA been corrupted? or any other explanation or test to undertake??
thanks ES.