Page 1 of 1

3d printable battery mounts for ebike Recumbent conversions

Posted: Aug 05 2019 1:27pm
by geeksville
Hi ya'll,

So I started helping out on @casainho's cool TSDZ2 because it looked like a fun SW project to futz with. And I got sucked into spending a bunch of time on the SW102 display software. I've only just now gotten around to installing the TSDZ2 on my bike. It is a recumbent bike so the standard locations to mount the battery are not really suitable, so I caded up some adapter brackets, here they are in case they are useful for anyone else:

https://imgur.com/a/Io1Ky6V
https://www.thingiverse.com/thing:3788903
Image

Re: 3d printable battery mounts for ebike Recumbent conversions

Posted: Oct 04 2019 4:07am
by Lubin
Hi ,

Looking at the way you attached the TSDZ2 to the frame without using using the TSDZ2 sandwith system which is not compatible with all frames.
How did you adjust parts to make theses firmly attached ? don't you get any slock ?
Btw, not sure I can reach such design. I am thinking about using hose clamp ring.