Following on from this thread .. https://endless-sphere.com/forums/viewtopic.php?f=28&t=88921&start=225
--------------------------------------------------------------------------------------------------------------------------------------------------
EDIT: Lots of changes and refinements happening these are the current versions -
EDIT 2: OK not quite the current version anymore :lol:
Follow on from here to see how I got to this point...
--------------------------------------------------------------------------------------------------------------------------------------------------
I'm considering a custom frame for the cyclone coaxial 4.8kw motor ( could also be for the dual drive set-up)
Here's where I'm at so far..
Note: The forks seat and rear end are from GrabCad - I just designed the frame in the middle.
Down tube is 85mm wide the whole way - tapering out vertically to 140ish at the motor mount.
Should easily fit 20s 6p - 7p or 8p if the whole down-tube was filled.
Thoughts for improvement?
--------------------------------------------------------------------------------------------------------------------------------------------------
EDIT: Lots of changes and refinements happening these are the current versions -
EDIT 2: OK not quite the current version anymore :lol:
Follow on from here to see how I got to this point...
--------------------------------------------------------------------------------------------------------------------------------------------------
I'm considering a custom frame for the cyclone coaxial 4.8kw motor ( could also be for the dual drive set-up)
Here's where I'm at so far..
Note: The forks seat and rear end are from GrabCad - I just designed the frame in the middle.
Down tube is 85mm wide the whole way - tapering out vertically to 140ish at the motor mount.
Should easily fit 20s 6p - 7p or 8p if the whole down-tube was filled.
Thoughts for improvement?