Camerinboy
1 mW
- Joined
- Mar 11, 2021
- Messages
- 17
I Currently have a 750w tsdz2 in bits Currently repairing a sensor fault. Whist its stripped down
1. Can i make it 8 pin?
2. do I add extra wires to make it 8 pin.
3. Does the firmware need upgrading as well... I have a spare 3 pin throttle. Ready to go....
The display is the standard display which is also 6 pin...do i wire extra wires from motor to display or simply add extra cable?
1. Can i make it 8 pin?
2. do I add extra wires to make it 8 pin.
3. Does the firmware need upgrading as well... I have a spare 3 pin throttle. Ready to go....
The display is the standard display which is also 6 pin...do i wire extra wires from motor to display or simply add extra cable?