mwkeefer
1 MW
Hello all,
Before going and doing something I'm sure to regret, I thought I should ask opinions here.
I have located in an old drawer an RC controller with good heatsink and programmable delays and power levels and cutouts and such.
I'm considering disconnecting the Lyen 6 FET sensored controller, leaving the loging system in place and seeing if there is a difference in heat / performance, etc.
Not even sure this will work but I doubt an additional 5A at 44.4v nominal should affect it - the power output is the same as 25A at 48v nominal isn't it?
What do you think before I toast a controller outright or worse a BBS02?
This would in theory with the right controller side cover allow us to embed RC style sensorless controllers right in the existing motor eliminating the needs for Bafang Controllers and opening up a very wide world of options to us.
-Mike
Before going and doing something I'm sure to regret, I thought I should ask opinions here.
I have located in an old drawer an RC controller with good heatsink and programmable delays and power levels and cutouts and such.
I'm considering disconnecting the Lyen 6 FET sensored controller, leaving the loging system in place and seeing if there is a difference in heat / performance, etc.
Not even sure this will work but I doubt an additional 5A at 44.4v nominal should affect it - the power output is the same as 25A at 48v nominal isn't it?
What do you think before I toast a controller outright or worse a BBS02?
This would in theory with the right controller side cover allow us to embed RC style sensorless controllers right in the existing motor eliminating the needs for Bafang Controllers and opening up a very wide world of options to us.
-Mike