TommyCat
10 kW
Good day everyone!
I have this working 1 hp blower motor and was wondering if it could be adapted for an electric bicycle use. Anyone attempt this?
Or is it one of those...well you could, but it wouldn't be worth it. :wink:
Thoughts are an external controller. But would like to install hall sensors. Perhaps above my pay grade. Sensor less then? Gear reduction.
Have to check and see what DC voltage it's firing on now.
Here are the particulars...
GE ECM 5SME39SG 1 HP 0-1300 rpm 115 volt 60 htz 12 amp motor
AKG03 0904 existing controller... no, don't plan on using.
I count 36 coils, 3 phase wires, and 6 magnet poles but no guarantees. (2 of the motor wire connectors are for a temperature cut-out)
Any comments and experience tips are certainly welcome!
Regards,
T.C.
I have this working 1 hp blower motor and was wondering if it could be adapted for an electric bicycle use. Anyone attempt this?
Or is it one of those...well you could, but it wouldn't be worth it. :wink:
Thoughts are an external controller. But would like to install hall sensors. Perhaps above my pay grade. Sensor less then? Gear reduction.
Have to check and see what DC voltage it's firing on now.
Here are the particulars...
GE ECM 5SME39SG 1 HP 0-1300 rpm 115 volt 60 htz 12 amp motor
AKG03 0904 existing controller... no, don't plan on using.
I count 36 coils, 3 phase wires, and 6 magnet poles but no guarantees. (2 of the motor wire connectors are for a temperature cut-out)
Any comments and experience tips are certainly welcome!
Regards,
T.C.