So I ended up fixing my x5304 about 5 times. Something is wrong with it. I swear i can't figure it out. Replaced the halls and phase. It seems to work for the first 500m even at hard accel and then gets jerky and dies. I think one of the halls is being rubbed to death or something every time.
So I tore my 5403 out of it's moto rim and threw it into my DH rim. The bike is AMAZING. With Zombies 100v controller set to 300amps it will wheelie the bike even with the batts on the front. It will climb a steep hill from a dead stop and never bogs down. I've been doing runs at about 70km/h across grass fields around Hurdman Hills in Ottawa and it's been solid as hell. Max speed in 26 inch rim with 3.0 Kenda Flame is 110km/h, after batts burn off top charge it settles to about 103km/h on flat. It regens hard enough to skid the back tire a tiny bit
the gorilla tape will go eventually
I have a friend who built a 3d printer so hopefully some nice abs things will soon hold my handlebar gear.
Since those pictures were taken I stacked the bike hard going off a hill into a ditch i didnt think was there. I broke the cryo fit on the front shock. Examining it however I found I had improperly installed it and that contributed to the failure significantly. My new shock arrived yesterday so I'm going to try and get it installed today.