Torque Arm Advice

S

sacko

10 kW
Joined
Jul 4, 2012
Messages
840
Location
Kent, United Kingdom
Looking to make or modify Docbass TA's. Apologies for the poor pictures. Ideally I would like to mount some TA's inside the frames, as you can see from this pic, there is 3mm I can remove with a grinder and file;

a4313ffd.jpg


I would like to install the following. Please excuse the template, it is just to illustrate the idea.

bae325ab.jpg


Something around 9mm thick steel. Does it look sufficient?
 
Depends a lot on the motor and power levels you intend to run.
 
Sould be more than sufficient for that. I'm curious, why inside the frame not outside? Running a front hub in there?
 
I see DM hit the multiple post bug too! Something's hanging up today!

Sorry OP, dunno that motor personally...
 
The Bafang is from BMS Battery.

I was going to run it on the inside, as the outside of the dropouts aren't flat. I'll upload a picture..
 
Looks to me like you could just make em to fit inside that notch. It's not that small.
 
Quite adequate for the wattage you will be running, and likely a lot more.
 
You must log in or register to reply here.

Similar threads

Greendog
Brushed alloy hardtail, 2000w 45amp KT, 52v 25r 50amp BMS, Mk1, 1st luv :)
Replies
5
Views
1,445
Greendog
Greendog
geosped
All Mountain trail Bike build and advice.
Replies
17
Views
3,105
ZeroEm
ZeroEm
E-HP
Torque arm design help
Replies
11
Views
1,310
Robert62
R
I
My version of BBSHD Torque Arm (2018.08) CAD file added 2022.08
Replies
5
Views
3,538
tomjasz
tomjasz
F
Gazelle Cabby Electric Conversion
Replies
5
Views
5,528
Fatherload
F
Back
Top