I have a standard MAC (10T) motor and am looking to build an 18650 pack.
Was going to make two 7S5P packs and run them in series so would end up with about 51.8V nominal and about 10.5AH.
Then I was thinking this morning why not optionally make a harness to parallel them and run on 26V? Will the MAC motor run OK with that?
Was going to make two 7S5P packs and run them in series so would end up with about 51.8V nominal and about 10.5AH.
Then I was thinking this morning why not optionally make a harness to parallel them and run on 26V? Will the MAC motor run OK with that?