Hi all,
After having had my enduro frame sitting around for the last six months I've finally had some time to put it together over the last few weeks - only to find out now that the rear drop outs are borked.
The enduro swing arm has torque plates on both dropouts, but on the deraileur side of the swing arm the main part of the arm and the plate are out of alignment - meaning there no way for me to get the wheell into the drop outs at the two pieces are askew. The deraileur mount holes line up though, which is weird
Has anyone had this problem here? any advice? I've emailed enduro but yet to hear back from them. Obviously i could just file one side back until I'm able to slot the wheel in, but that completely defeats the point of the torque plate as it wont be a tight fit on both sides.
This is all rather disappointing
After having had my enduro frame sitting around for the last six months I've finally had some time to put it together over the last few weeks - only to find out now that the rear drop outs are borked.
The enduro swing arm has torque plates on both dropouts, but on the deraileur side of the swing arm the main part of the arm and the plate are out of alignment - meaning there no way for me to get the wheell into the drop outs at the two pieces are askew. The deraileur mount holes line up though, which is weird
Has anyone had this problem here? any advice? I've emailed enduro but yet to hear back from them. Obviously i could just file one side back until I'm able to slot the wheel in, but that completely defeats the point of the torque plate as it wont be a tight fit on both sides.
This is all rather disappointing