DrInnovation
100 W
I have an bike kit I bought on craigslist. Have it hooked up and running but last week it cut out and the "three leds" (red=low, yellow=medium, green = high) showed only red and green (i.e. skipping medium) Does anyone have an idea what that indicates? Turning on/off did not reset, but kept it off and fiddled with e-brakes and got it to work again don't know what fixed it. I wondered if it was a LCV, but tested when I got home and had 39.8v (36v nominal, full charge is 42) or could it be something with ebrakes?
The pack is something I built from recycled 18650s.. its 19ah 36v.. and I had maybe 12 miles on it when I had the issue. I was not pushing it hard on a hill or anything that might really draw down. (I'll eventually get my celllog on it but have to figure out what to do with 10s.. )
Also any idea if the above controller/throttle could be compatiable with a PAS-based sensor. My wife does not like thumb throttles after a crash, but I might get her on one that has a PAS.
The pack is something I built from recycled 18650s.. its 19ah 36v.. and I had maybe 12 miles on it when I had the issue. I was not pushing it hard on a hill or anything that might really draw down. (I'll eventually get my celllog on it but have to figure out what to do with 10s.. )
Also any idea if the above controller/throttle could be compatiable with a PAS-based sensor. My wife does not like thumb throttles after a crash, but I might get her on one that has a PAS.