Hi guys
I was wondering if this is ok for torque arm attachment? I got some generic M16 axle sized torque arms and this seems to be the only way to mount the main piece that slides over the axles.
I was thinking on mounting them on the inside of the frame but its too tight of a fit and too close to the freewheel.
Also, is it ok to have the torque arms bascially be as large washers for the axle nuts? I seen some photos of another person who had his motor nut tightened against the bike frame then the torque arm on the outside of the nut and then another nut on the remaining few available threads on the outside.
At the moment i dont have extra nuts to do that.
Thanks for your input!
I was wondering if this is ok for torque arm attachment? I got some generic M16 axle sized torque arms and this seems to be the only way to mount the main piece that slides over the axles.
I was thinking on mounting them on the inside of the frame but its too tight of a fit and too close to the freewheel.
Also, is it ok to have the torque arms bascially be as large washers for the axle nuts? I seen some photos of another person who had his motor nut tightened against the bike frame then the torque arm on the outside of the nut and then another nut on the remaining few available threads on the outside.
At the moment i dont have extra nuts to do that.
Thanks for your input!