spinningmagnets wrote: ↑
Jun 10, 2018 7:16 pm
Those TA's may not be pretty, but...you have two of them, and they look STRONG!
I am quite fond of them, I used a wide thick cutoff wheel on a grinder and was a bit off. Would have been better to use a thin one to cut the sides, then the wide one to get the rest.
Just now, after 65km ride out to Cochrane AB from the Tuscany Train to do some fishing, I noticed my left pedal is frocked. My brand new pedal from CRC. Luckily I have spare crank arms and pedals.
Another thing is noise is coming from the motor. I am thinking it is the axle bearings but am unsure because when I start off walking it, no noise. Add 375lbs go slow, no noise. Started happening right after my axle spinout. Its very preculiar. I move wheel by hand sideways and dont feel no movement. And sometimes when I start from stop, the halls give mixed signals, go forward a inch, then its reversed. So, I am thinking wires are touching the conductor, so cut/shaved insulation perhaps on the phase.