PAS Sensor for my Catrike Trail

CatrikeMan · Jul 6, 2018

I have a Catrike Trail that I want to convert to electric power due to a knee injury. The crankset is an FSA CK6028. Most of the cadence counting PSA sensors work with a square taper shaft. The FSA set has a splined shaft. Any ideas?

Thanks,

Walt

amberwolf · Jul 6, 2018

Sure; there's a few threads/posts with options others have tried/suggested, but it may take some searching/reading.

Otherwise, you could just take the magnets off the plastic ring and put them on the chainrings, then take the sensor off it's bracket and put it on whatever mount you have/make/etc.

CatrikeMan · Jul 6, 2018

amberwolf said:
Sure; there's a few threads/posts with options others have tried/suggested, but it may take some searching/reading.

Otherwise, you could just take the magnets off the plastic ring and put them on the chainrings, then take the sensor off it's bracket and put it on whatever mount you have/make/etc.

Thanks!

Walt

PAS Sensor for my Catrike Trail

CatrikeMan

10 µW

amberwolf

Administrator

CatrikeMan

10 µW

Similar threads