I recently had a MXUS 3k 3T clone here.
Unfortunately it only had a M14 axle although advertised with M16 axle, but it had significantly less phase-to-phase resistance than the original mxus v3 3T (including phase wires 55mohms vs. 67mohms)
Both are winded 21x3T (the original mxus has 24x3T written inside, but it is also only 21x3T).
The copper winding wire diameter of the clone is thicker (0.57-0.58mm vs. 0.52-0.53mm) which is causing the lower resistance.
Did anybody already (re)wind such a stator and is the winding of that clone already close to the maximum copper fill?
Unfortunately it only had a M14 axle although advertised with M16 axle, but it had significantly less phase-to-phase resistance than the original mxus v3 3T (including phase wires 55mohms vs. 67mohms)
Both are winded 21x3T (the original mxus has 24x3T written inside, but it is also only 21x3T).
The copper winding wire diameter of the clone is thicker (0.57-0.58mm vs. 0.52-0.53mm) which is causing the lower resistance.
Did anybody already (re)wind such a stator and is the winding of that clone already close to the maximum copper fill?