Securing Hall Sensors

Ready to close up this motor minus the proprietary controller and plus a new L10 and statorade. But the hall sensor leads slip around in their sleeves. Is this going to be a problem. The sensors don't seat and can slide out and protrude. A little glue maybe? CA glue? The sensors used to be anchored by the old internal controller.

It would be bad if the sensors moved and made contact with the rotor. Most motors use epoxy to hold them. High temp epoxy would be the best.

It needs to be fixed. silicone would also work, can take high temps, cheap, removable. i've tried that and epoxy and CA+baking powder for halls, all of them worked well.