Are someone actually used motorcutback with sevcon and was it working and cutting power/torque?
I raced in the weekend and for me it seems that it is not working and I can not see any real cutback.
As you can see that at 122 degrees it should give me only 0,4 or 40% of torque. And then linear got to 0,1 at 130 degrees.
But in reality It was still 60% or 0,6 that I have configure in baseline profile until 129 degrees. Here is two graphs from saved data (one is whole race and another closeup).
You can see 40% of demand torque when we switched manually to profile 2 (where I have configured 40% or 0,4 for demand torque)
So is there something els somewhere deep that needs to be configure so this motor cutback will actually work?
I raced in the weekend and for me it seems that it is not working and I can not see any real cutback.
As you can see that at 122 degrees it should give me only 0,4 or 40% of torque. And then linear got to 0,1 at 130 degrees.
But in reality It was still 60% or 0,6 that I have configure in baseline profile until 129 degrees. Here is two graphs from saved data (one is whole race and another closeup).
You can see 40% of demand torque when we switched manually to profile 2 (where I have configured 40% or 0,4 for demand torque)
So is there something els somewhere deep that needs to be configure so this motor cutback will actually work?